Steadicam Monitor Power Cable

$225.00
Current Stock:
0
Availability:
Usually ships within 1-2 weeks.

Cable Length required
Cable Type required
BNC Combo

These Steadicam monitor power cables allow you to power your monitor from the dedicated 8-Pin Lemo MONITOR port on your lower stage. Please note that we do not typically connect the tally and analog video connections for HD monitors as a way to keep costs low. The exception is when ordering a TB-6 monitor cable, which will be wired for analog video and tally. If you do not see your monitor type listed, please send us an email for a custom order.

By default, all Steadicam monitor power cables will be fitted with a 90-degree connector into the sled, with the exception of the Tiffen M1 sled (unless requested).

Cable Type

We offer two types of cable. The standard cable type used for most cables is the Canare L-2E5 with an outer diameter of 4.6mm. This cable is braided, shielded, and extremely flexible and durable, without being too thick. It is a great durable and economical option for most power cables. Our Ultra-Thin cable type has an outer diameter of 2.9mm and is extremely thin and flexible. It is a great companion cable to our Ultra-Thin BNC cable type. This cable is excellent for weight critical operation, such as for gimbal work, steadicam work, or any application where weight and flexibility are essential. While it is not the most durable cable due to its very thin diameter, with proper care it will last many years.

BNC Combo Cable:

Choosing to combine your power cable with a BNC cable is a great way to reduce cable clutter on the camera or steadicam. The BNC used is genuine Canare brand coaxial cable and connectors rated for 3G HD-SDI monitoring up to 4 feet, the same cable used in our Ultra-Thin BNC cable assemblies. It is the thinnest and most flexible BNC cable we make. We join the two cables together in a single expandable nylon sheath before the final connectors are assembled. This allows us to use the smallest diameter sheathing to minimize overall cable diameter. By default, the BNC length will match the final cable length. The sheathing ends approximately 2-3 inches from the connector ends, allowing the power and BNC connectors to separate by approximately 4-6 inches from each other at the camera end. If you require a longer BNC joined to a shorter power cable, please get in touch with us for a custom assembly.

Engineered Cinema Solutions assumes no liability for damage to equipment due to sources with incorrect polarity or voltage. All cables are assembled by hand using genuine components and tested.